PLATING PROCESS

ml beaker or you may use the cap from the solution bottle.

2. Attach the clean piece of jewelry to the (-) lead. Plug the

pen into the positive outlet on the rectifier. If using a

disposable pen, follow instruction for pen plating with

disposable plater.

3. Use at room temperature.

4. Place the felt tip of the plating pen into the plating

solution for 1-2 minutes.

5. Turn on the rectifier and set at 4 volts.

6. Take the pen in hand and place the felt tip onto the piece

to be plated.

7. Slowly move the felt tip back and forth over the area that

you wish to pen plate. The pen tip should not be dripping

solution onto the piece, so please shake off all excess

solution that was not absorbed into the felt tip. The back

and forth motion may have to be repeated several times

before the desired results are achieved.

8. Be sure to rinse off the piece under hot tap water

immediately after pen plating. Do not rinse the piece off

until the desired results are achieved.

9. Return all solution to the original bottle for safe storage.